adam
06-29-2004, 09:04 AM
Aplyied a technique called Density Mask in PS. These are the steps:
1-Duplicate the image (Image>Duplicate)
2-Make it B&W (Image>Mode>Grayscale)
3-Invert the image (Image>Adjustments>Invert)
4-Blur the image (Filter>Blur>Gaussian Blur: 2 pixels)
5-Go back to the original image and load the B&W image as a selection layer (Select>Load Selection: click OK)
6-Apply the mask ((Layer>New Adjustment Layer>Curves: click OK)
7-On the Layers palette change the Blend mode (upper left corner) from Normal to Screen
8- neatimage
This technique was descrive by Surfer31
1-Duplicate the image (Image>Duplicate)
2-Make it B&W (Image>Mode>Grayscale)
3-Invert the image (Image>Adjustments>Invert)
4-Blur the image (Filter>Blur>Gaussian Blur: 2 pixels)
5-Go back to the original image and load the B&W image as a selection layer (Select>Load Selection: click OK)
6-Apply the mask ((Layer>New Adjustment Layer>Curves: click OK)
7-On the Layers palette change the Blend mode (upper left corner) from Normal to Screen
8- neatimage
This technique was descrive by Surfer31